Bild nicht verfügbar

Überblick

The CABLE3CBL-L is a 22 AWG, three-conductor cable with a Santoprene jacket and an aluminum Mylar shield. The conductors are stripped and tinned, and have red, black, and white insulation colors.

Lesen Sie mehr

Technische Beschreibung

The CABLE3CBL-L is a 22 AWG, three-conductor cable with a Santoprene jacket and an aluminum Mylar shield. The conductors are stripped and tinned, and have red, black, and white insulation colors.

FAQs für

Number of FAQs related to CABLE3CBL-L: 2

  1. Is there a specific type of wire that should be used to connect the 12 V and ground terminals on the CE4 or CE8 and the datalogger?

    Campbell Scientific recommends using the CABLE3CBL-L, a 22 AWG cable with three conductors and a drain wire. However, any type of copper wire between 18 AWG and 22 AWG could be used to control the CE4/CE8.

  2. If the cable attached to a sensor is too short, can more cable be spliced to the existing cable to make it longer?

    Whenever possible, purchase a sensor with the desired cable length. Some sensors have a user-specified cable length, whereas other sensors have a set cable length.

    Sometimes, an old cable can be replaced with a new, longer cable.

    Generally, additional cable cannot be spliced onto the existing cable because:  

    • Some sensor cables have bridge completion resistors at the pigtail end
    • Some sensors are calibrated based on cable length
    • Sometimes the color in the insulation is not the same as that visible at the pigtail end
    • It is possible to introduce errors or malfunctions depending on the integrity of the splice

    Splicing cable together increases the likelihood that water may enter the cable and cause shorting, corrosion, and some other potential issues, which in turn can cause measurement issues.

    Because of the potential issues, do not splice any sensor cable without first contacting Campbell Scientific to discuss the sensor in detail.

Gehen Sie zumVerzeichnis der FAQs