Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Problem with CR3000


VVitolo Jan 12, 2019 03:16 AM

We have a problem with a CR3000. The serial and ethernet port has stopped working. We wanted to know if there is any way to configure the C5 and C6 pins with Tx and Rx to be able to access the cr3000 via serial port, bearing in mind that we can not use the Dev Conf and we would have to do it from the keyboard/display


GaryTRoberts Jan 12, 2019 10:48 AM

Yes, Just set the baud rate of Com3 to 115200. This should turn the port on and you can then connect to the logger using DevConfig or LoggerNet to collect the data. Via the keyboard display go to Configure, Settings -> Comports -> Com3 -> Baudrate.


VVitolo Jan 13, 2019 02:36 PM

Dear Gary,

thank you for your replay. We wlll try to test your solution and post replay.

Best regards

Log in or register to post/reply in the forum.