MetSENS200 Kompakter Windsensor mir Kompass
Misst Windgeschwindigkeit und -richtung
inclusive Kompass
wetter wasser energie gas flux and turbulence bauwerke boden


Der MetSENS200 ist ein kompakter Sensor für Windgeschwindigkeit und- richtung mit eingebautem Kompass. Er bestimmt die mittlere Windgeschwindigkeit nach WMO und Daten zu Böen (gusts).

Der MetSENS200 kann SDI-12, RS485, ModbusRS-485 oder NMEA RS-232 ausgeben und ist damit kompatibel mit dem MeteoPV Solar Resource Platform und allen neueren Campbell Datenloggern.

Funktionen und Vorteile

  • Hochwertige Messungen
  • Einfach und schnell zu installieren
  • Kompaktes Design
  • Robust und leicht


Cable for the MetSENS200


Measurements Made Wind direction and wind speed.
Sampling Rate 1 Hz
Digital Communication Modes Serial RS-232, RS-485, SDI-12, NMEA, Modbus, ASCII
IP Rating 66
Compliance CE, RoHS
Operating Temperature Range -40° to +70°C
Operating Voltage 5 to 30 Vdc
Typical Current Drain @ 12 Vdc
  • 25 mA (continuous high mode)
  • 0.7 mA (eco-power mode; 1 hour polled)
Weight 0.5 kg (1.1 lb)

Wind Speed Measurement

Measurement Range 0.01 to 60 m s-1
  • ±3% (up to 40 m s-1)
  • ±5% (up to 60 m s-1)
Resolution 0.01 m s-1
Starting Threshold 0.01 m s-1

Wind Direction Measurement

Measurement Range 0° to 359°
Accuracy ±3° (up to 60 m s-1)


Measurement Range 0 to 359°
Units of Measure Degrees
Accuracy ±3°


MetSENS200 Example Programs v.1 (4 KB) 25-09-2019

Three CR1000X data logger programs that read the MetSENS200 measurements and sensor status. An example program is included for each output option (RS-232, Modbus, SDI-12).

FAQs für

Number of FAQs related to MetSENS200: 1

    • MetSENS has a compass module that outputs at 1 Hz real time without affecting any other measurements, which allows the correction of wind direction if the station is installed on moving ice.
    • MetSENS has a two-year service life, which is especially helped by the use of a double-louvered radiation shield to reduce the flow of contaminants getting to the temperature/humidity probe.
    • MetSENS has an option for GPS.
    • MetSENS has a wind speed resolution of 0.01 m/s, whereas most all-weather sensors have a resolution of 0.1 m/s.
    • MetSENS has a dew point accuracy of ± 0.3°C, whereas most all-weather sensors have an accuracy of > ±0.7°C.
    • MetSENS temperature resolution is for the full-range temperature at 0.1°C, whereas other all-weather sensors change to 0.2° at the extremes.
    • MetSENS offers users the option to use any industry-standard tipping bucket rain gage (MetSENS550).
    • MetSENS provides RS-232, RS-485, Modbus, and SDI-12 from all models.
    • MetSENS uses Intelligent Signal Processing (ISP) and Adaptive Gain Control (AGC), which have been proven worldwide to provide good quality data.
    • MetSENS does not indicate a drop in wind speed if the temperature drops or if rain occurs, whereas this is fairly common in other all-weather sensors.

Aufgelistet unter

Common Accessory for the following products: