Strahlungssensoren / SN500SS
Digitaler Strahlungsbilanzsensor
Überblick
Dieser Vier-Komponenten Strahlungsbilanzsensor von Apogee Instruments liefert individuelle Messwerte der vier Komponenten als SDI-12 Signal. dadurch werden weniger analoge Kanäle gebraucht und man erhält trotzdem alle Informationen vom Sensor. Inklusive mit dem Sensor sind ein Montagearm, Kabel zum Anschluss am Datenlogger und ein Transportkoffer.
Bilder
Spezifikationen
| Sensor | Two thermopile pyranometers, two pyrgeometers |
| Measurement Description | Measures incoming and outgoing short-wave and long-wave radiation |
| Heater | 62 mA current drain and 740 mW power requirement at 12 Vdc |
| Operating Temperature Range | -50° to +80°C and 0 to 100% humidity |
| Response Time | 1 s (SDI-12 data transfer rate; detector response times are 0.5 s) |
| Heater Current Drain |
|
| Dimensions | 11.6 x 4.5 x 6.6 cm (4.6 x 1.8 x 2.6 in.) |
| Weight | 320 g (11.29 oz) with mounting rod and 5 m (16.4 ft) of lead wire |
Pyranometer |
|
| Spectral Range |
|
| Sensitivity |
|
| Expected Output Range |
|
Pyrgeometer |
|
| Spectral Range | 5,000 to 30,000 nm |
| Sensitivity | 0.12 mV per W/m2 |
| Expected Output Range | -24 to +24 mV |
Dokumente
Broschüren Produkte
Handbücher
Downloads
SN500SS Program Example (1 KB) 11-08-2021
An example program that uses the M! SDI-12 command to measure the incoming short-wave (SW) radiation, outgoing SW radiation, incoming long-wave (LW) radiation, and outgoing LW radiation of the SN500SS. The example program supports the CR6 and CR1000X data loggers.
Anwendungsbeispiele
Overview In the fight against climate change, innovative solutions are emerging to address the global challenge......lesen Sie mehr
Aufgelistet unter
Common Accessory for the following products: