Our support team has been notified.
Vibrating-wire sensors are recognized as the optimal sensor for long-term deployments. Vibrating-wire sensors offer true “return to zero,” unparalleled long-term stability, and uncompromised temperature correction. For this reason, Campbell Scientific data-acquisition (DAQ) systems have been used for decades to monitor the output of vibrating-wire sensors.
While vibrating-wire sensors provide excellent measurements, there are still some challenges to overcome. Campbell Scientific engineers were approached years ago and asked if they could develop a device that could overcome the challenges inherent to these sensors. They identified four areas of concern:
Campbell Scientific was able to address each of these areas of concern as they developed the spectral analysis approach to measuring vibrating-wire sensors. This patented VSPECT® technology has been incorporated into several Campbell Scientific measurement devices. Each provides:
Structural and geotechnical engineers often use vibrating-wire sensors to measure strain, pressure, tilt, displacement, and load. These sensors have a reputation for being accurate, stable, and durable—making them well suited for long-term static monitoring. Despite their acceptance, vibrating-wire sensors are sometimes plagued by a susceptibility to external electromagnetic noise and loosening, over time, of the vibrating-wire within the sensor. This weakness can produce unusable data, requiring data analysts to devote considerable effort to qualifying their data. This susceptibility to external noise is especially difficult in real-time alarm systems where post-collection analysis is not possible. Post-collection analysis is also time consuming and expensive.
This web resource discusses a frequency-domain approach that uses spectral analysis to read vibrating-wire sensors, which improves noise immunity, introduces additional diagnostics, and improves measurement precision when compared to traditional time-domain methods. Fig. 1 shows this improved noise immunity when a drill motor was used to simulate external noise interference near a vibrating-wire strain gage.
Although the actual strain changed by only a few tenths of a µstrain during the test, the time-domain analysis gave errors of 12,000 µstrain. As shown in Fig. 2, the spectral analysis gave errors of typically less than ±0.5 µstrain during the same noise event.